95-Percentile wont' work

lorcs

08-04-2005 12:25:08

I installed version 0.18 in Fedcore 3 and use it to monitor the interface utilizaton for Cisco routers. The utilization graph is OK for all the interfaces but when I add in the 95-percentile graph, I can't see any 95-percengile curve on the graph and nor does the figures. I check the log and it shows up following and don't know what these message means.

04/09/2005 100011 AM - CMDPHP Poller[0] Host[2] WARNING Result from SNMP not valid. Partial Result
04/09/2005 100011 AM - CMDPHP Poller[0] Host[2] WARNING Result from SNMP not valid. Partial Result
04/09/2005 100000 AM - POLLER Poller[0] Maximum runtime of 296 seconds exceeded. Exiting.
04/09/2005 100000 AM - POLLER Poller[0] Maximum runtime of 296 seconds exceeded. Exiting.

silfreed

08-04-2005 13:59:01

You're confusing us with Cacti. We don't support 95-percentile yet. Try over on their forums.

-Doug